Manual

Chapter
6
61
Connections to Field Wiring Arms
This chapter will help you:
Connect the field wiring arms of chassis A and B
install either ungrounded or grounded 120V AC power distribution
Before continuing, be sure that you configured your clutch/brake
controller chassis and modules as shown in chapter 3. For installation
details, refer to the installation publication for your processor. These
publications are listed in our Publications Index (publication SD499).
In order to design, build, install, and operate a safe press system, you
should also refer to other publications. In addition to local codes and
laws, adhere to safety requirements detailed in the following publications.
OSHA Regulations, Title 29-Labor, Chapter XVII, Section 1910.217,
Mechanical Power Presses
ANSI B11.1, American National Standard for Machine Tools,
Mechanical Power Presses, Construction, Care and Use
NFPA No. 79, Electrical Standard for Metalworking Machine Tools
Some electrical connections are mandatory, others are optional. If you
omit mandatory connections or electrical components, you violate safety
requirements discussed and referred to in this manual.
For AC
Power
That Is
Use This
Mandatory
Figure
For these Connections
Ungrounded 6.1 AC Power and Crowbar T est Inputs
Press Interlock Switch
Ungrounded
or
6.3 Main and Auxiliary V alve Solenoids
Crowbar and Seal Relays
MOV Surge Suppression
Grounded 6.5 AC Power and Crowbar T est Inputs
Press Interlock Switch
Grounded 6.7 Main and Auxiliary V alve Solenoids
Crowbar and Seal Relays
MOV Surge Suppression
Chapter Objectives
Installation Considerations
Electrical Connections and
Safety Requirements