Manual

Troubleshooting
Chapter 7
732
diagnostic message codes are displayed by indicators connected to module group 5, slot 1 (figure 6.18), or by displaying the corresponding
data table word using the industrial terminal.
Use this table in conjunction with figure 7.1 and figure references shown in parentheses.
T ype of Message
N = Nonlatched
L = Latched
T = T rip Condition
Code
P = at Powerup
Alt = Alternate chassis
Ethr = Either chassis
Top = T op chassis
Bot = Bottom chassis
Binary Diagnostic Message (figure References) CodeTypeHex
T ransition to Upstroke
(Figures 5.1, 6.1 1)
1001 1010 9A L Runon cam switch open.
1001 101 1 9B L Alt Runon cam switch open.
1001 1 100 9C L Brake monitor cam switch bounced or motion reversed.
1001 1 101 9D L Alt Brake monitor cam switch bounced or motion reversed.
Upstroke
(Figures 5.1, 6.1 1)
1001 1 110 9E L Brake monitor closed when runon cam switch opened.
1001 1 111 9F L Brake monitor for this chassis closed when runon cam switch for the other chassis is open.
1010 0000 A0 L Brake monitor for this chassis closed when runon cam switch for the other chassis is open.
1010 0001 A1 L Alt Brake monitor closed when runon cam switch is open.
1010 0010 A2 L Brake monitor cam switch closed, showing reverse motion.
1010 001 1 A3 L Alt Brake monitor cam switch closed, showing reverse motion.
T ransition to Near Top Zone
(Figures 5.1, 6.1 1)
1010 0100 A4 L Brake monitor cam switch closed.
1010 0101 A5 L Alt Brake monitor cam switch closed.
1010 01 10 A6 L Runon cam switch bounced or motion reversed.
1010 01 11 A7 L Alt Runon cam switch bounced or motion reversed.