Manual

Troubleshooting
Chapter 7
730
diagnostic message codes are displayed by indicators connected to module group 5, slot 1 (figure 6.18), or by displaying the corresponding
data table word using the industrial terminal.
Use this table in conjunction with figure 7.1 and figure references shown in parentheses.
T ype of Message
N = Nonlatched
L = Latched
T = T rip Condition
Code
P = at Powerup
Alt = Alternate chassis
Ethr = Either chassis
Top = T op chassis
Bot = Bottom chassis
Binary Diagnostic Message (figure References) CodeTypeHex
011 1 01 10 76 L Motion detector signal missing during onthehop downstroke. (5.1, 6.17)
011 1 01 11 77 L Motion detector signal missing during second downstroke. (5.1, 6.17)
011 1 1000 78 L Motion detector signal missing during continuous cycle. (5.1, 6.17)
011 1 1001 79 L Motion detector signal missing at near bottom. (5.1, 6.17)
011 1 1010 7A L Motion detector signal missing at near top. (5.1, 6.17)
011 1 101 1 7B T Motion detector signal comes on while press is stopped. (6.17)
0111 1100 7C T Motion detector signal remains on after press stops. (6.17)
0111 1101 7D Not used.
0111 1110 7E Not used
0111 1111 7F Not used
Faulty Cam Limit Switch
Near T op Position
(Figures 5.1, 6.1 1)
1000 0000 80 L Brake monitor and runon cam switches both closed.
1000 0001 81 L Brake monitor for this chassis and runon cam switch for the other chassis both closed.
1000 0010 82 L Brake monitor for this chassis and runon cam switch for the other chassis both closed.
1000 001 1 83 L Alt Brake monitor and runon cam switches both closed.
1000 0100 84 L Runon cam switch closed, showing reverse motion.
1000 0101 85 L Alt Runon cam switch closed, showing reverse motion.
T ransition to Downstroke
(Figures 5.1, 6.1 1)
1000 01 10 86 L Runon cam switch closed.
1000 01 11 87 L Alt Runon cam switch closed.