Manual

Troubleshooting
Chapter 7
729
diagnostic message codes are displayed by indicators connected to module group 5, slot 1 (figure 6.18), or by displaying the corresponding
data table word using the industrial terminal.
Use this table in conjunction with figure 7.1 and figure references shown in parentheses.
T ype of Message
N = Nonlatched
L = Latched
T = T rip Condition
Code
P = at Powerup
Alt = Alternate chassis
Ethr = Either chassis
Top = T op chassis
Bot = Bottom chassis
Binary Hex Type Code Diagnostic Message (figure References)
01 10 001 1 63 L RUN button in station 1 released too late in the downstroke.(5.3,5.6,6.13)
01 10 0100 64 N Antirepeat cam switch open while awaiting start or restart of downstroke (6.1 1)
01 10 0101 65 N Alt Antirepeat cam switch open while awaiting start or restart of downstroke (6.1 1)
01 10 01 10 66 L Antirepeat cam switch open during downstroke (6.1 1)
01 10 01 11 67 L Alt Antirepeat cam switch open during downstroke (6.1 1)
Upstroke Fault
01 10 1000 68 L Runon cam switch opened too soon, or antirepeat cam switch closed continuously. (6.1 1)
01 10 1001 69 L Alt Runon cam switch opened too soon, or antirepeat cam switch closed continuously. (6.1 1)
01 10 1010 6A N A waiting release of all RUN button. (6.13 thru 6.16)
01 10 101 1 6B N A waiting release of all RUN button. (6.13 thru 6.16)
Fault in Setup for Continuous Mode
01 10 1 100 6C N A waiting release of ARM CONTINUOUS button. (5.5, 6.12)
01 10 1 101 6D N Continuous cycle not armed. (5.5)
01 10 1 110 6E N A waiting PC to inhibit stopontop signal. (4.5, 4.7)
01 10 1 111 6F N A waiting release of all ST OPONT OP buttons. (6.12)
011 1 0000 70 N RUN button released during first upstroke in continuous mode. Inch to op. (5.7,6.13 thru 6.16)
011 1 0001 71 N Shaft not near top. Inch to top. (5.1)
Faulty Brake or Motion Detector
011 1 0010 72 N Faulty brake. reset swingarm power . (5.2, 5.4, 5.8)
011 1 001 1 73 N Faulty brake. reset swingarm power and inch to top. (5.2, 5.4, 5.8)
011 1 0100 74 L Motion detector signal missing at start of downstroke. (5.1, 6.17)
011 1 0101 75 L Motion detector signal missing during upstroke. (5.1, 6.17)