Instruction Manual

Assembly and Installation
Chapter 2
230
125V
dc (voltage) 10mA maximum load current.) analog circuit and control logic)
T emperature Coeffeicient Digital Resolution Keying
+ 50 ppm/
0
C 12bit binary , 1 part in 4095 Left connector (slot 0) between 8
T ieback Inputs Accuracy and 10, 18 and 20
Number + 0.1% of range at 25
0
C Right connector (slot 1) between 2
tieback input 1 T emperature Coefficient and 4, 28 and 30
tieback input 2 + 50 ppm/
0
C
[1]
If all analog outputs and tieback inputs
Configuration Contact Output used are selected to current mode, the
Single ended Number compliance of the analog outpus can be
Range (userselectable) one normally closed contact,held extended from 500ohms (standard compli
+4 to +20mA open ance to 1250 ohms(additional compliance).
+1 to +5V dc Peak V oltage This is achieved by internally referencing the
30V outputs to 15V dc.