Installation Instructions Instruction Manual

AC (120/220V) 16A Power Supply4
Publication 17715.39  December 1995
If you are mounting the power supply Go to
on the left side of a panelmounted I/O chassis next section
separately from an I/O chassis page 6
Attaching to a Panelmounted I/O Chassis
1. Attach the mounting screws to the side of the I/O chassis
as shown:
!
ATTENTION: Use the mounting screws provided
with the 1771-P7. Longer screws may intrude into
the I/O chassis and interfere with module insertion.
large screw
lockwasher
shoulder washer
Tighten this screw.
two small screws
and lockwashers
Loosely attach these screws.
leftside of I/O chassis
13446
2. Connect the power cable (ordered separately) to the D-shell
connector on the I/O chassis and tighten the connector screws.
Dshell connector
1771CP1 cable
connector screws
leftside of I/O chassis
13447