Manual

Module Installation
Chapter 3
3-10
Figure 3.6
Data Highway Cable Connection
Trunkline
1770–SC Station Connector
Dropline
(100 feet maximum)
Communication Adapter
Module (cat. no. 1771–KA2)
Program Panel Interconnect Cable Connection
The center connector of the communication adapter module is labeled
PROGRAM INTERFACE. When the module is installed and connected
to the processor, this socket connects an industrial terminal system (cat.
no. 1770–T1, –T3).
To connect with any of these terminals, use the program panel
interconnect cable (cat. no. 1772–TC). Figure 3.7 shows the
programming terminal connections to the communication adapter module.
When an industrial terminal is connected this way, you can perform all
terminal functions except cassette loads, or dumps. You must disconnect
the KA2 perform these functions.