Owner's manual
B–4 Programming Examples
-&)('%,(+* / -).
The following is a sample procedure for entering data in the
configuration words of the block transfer write instruction when
using a PLC-5 processor and 6200 programming software.
1. Enter the following rung:
$#!
"
"
!
!
!
!""
$
$
$
$$$$
!#
N7:60 is the address of the BTW transfer file
2. Press [F8] (data monitor),[F5] (change address) and enter N7:60
to display the configuration block.
The industrial terminal screen should look like Figure B.3.
3. Enter the data corresponding to your bit selections and add
scaling values, if scaling is desired.
4. [ESC] returns you to the ladder program.
Use this template for your appendices. If it were not for the different
running head, this would be your chapter 4 document.