Owner's manual
B–2 Programming Examples
/(+*)'.*-, 1 /+0
The PLC-2 family write block transfer data file should look like
Figure B.1.
"
& " "
" ! $ "
#
1
"
!" "
"
Following is a sample procedure for entering data in the
configuration words of the write block transfer instruction when
using a PLC-3 processor.
To enter data in the configuration words, follow these steps:
Example:
Enter the following rung for a write block transfer:
"
"
% $ "
#
#
"
"
"
"
F0003:0000 is the address of the write block transfer data file. You
want to enter/examine word 1.