Owner's manual

Getting Started with Your ASCII Module
Chapter 2
22
PLC2 Family Processors
You will demonstrate the operation of your ASCII module by reading data
from the industrial terminal to the processor data table, and by writing
data from the data table to the industrial terminal. You will use your
industrial terminal as an ASCII device for entering data (read), and for
displaying data (write).
You will need to set up a PC processor with an I/O chassis, power supply,
industrial terminal, cables, and your ASCII module. You will need about
an hour to complete the tutorial exercises in this chapter, and about two
hours to complete those of chapter 3, once you have the equipment
operating properly.
Equipment That You Need
You will need the following equipment (Table 1.A) using your existing
system and/or spare equipment.
Table 1.A
Equipment
(PLC2 Family)
Equipment Catalog Number
ASCII I/O module 1771DA
Industrial T erminal 1770T3
PLC2 Family Keytop Overlay 1770KCB
Alphanumeric Keytop Overlay 1771KAA optional
Processor Interface Cable 1772TC
IT/DH Adapter Cable 1770CB (figure 1.4)
I/O Chassis 1771A1, A2, A4
Processor PLC2/20, 2/30
Power Cable 1771CJ, CK
I/O Interconnect Cable 1777CB, CA
Local Adapter Module 1771AL
T ermination Plug 1777CP
What You Need to Get Started