Manualshelf

Owner's manual

ManualsBrandsRockwell Automation ManualsEquipment1771-DA,D17716.5.13 U MNL 1771-DA ASCII I/O MODULE
131132133134135136137138139140
Handshaking
Chapter 5
56
A write (only) program requires only write handshaking. A read/write
program requires read and write handshaking.
The module can handle handshaking and data simultaneously. For
example, read block transfers could contain new data and
acknowledgment of the previous write block transfer.
Refer to “Complete Getting Started Program,” Appendix A for PLC-2
family and for PLC-3 controllers. Handshaking bits in the ASCII
module’s command and status words used in these programs are defined
as follows:
Word Bit Description
PLC2
Address
PLC3
Address
Command
Word 1
15
16
CW1(15)
CW1(16)
200/15
200/16
WD002:0000/15
WD002:0000/16
Status
W
ord 1
15
16
SW1(15)
SW1(16)
252/15
252/16
WD003:0000/15
WD003:0000/16
Choose program addresses that are compatible with your programming
needs.