User Manual

2–4 Installing Your ControlNet Adapter Module
Publication 1771-6.5.124 – August 1997
The switches on the top of the adapter module determine the network
address of the adapter. The two switches are:
• the ten’s switch
• the one’s switch
The combination of these switches allows selection of network
addresses from 01 to 99.
Use a small bladed screwdriver to rotate the switches.
Figure 2.2
Setting the Network Address
Ten’ s Selection
One’ s Selection
Ten’ s Selection One’ s Selection
NET ADDRESS
10 5 = 15 plus
For example, the 10’s selection switch is set to 10,
and the 1’s selection switch is set to 5.
NOTE: 00 is an invalid number .
Then,
Setting the Network
Address Switches