Instruction Manual

Constructing a DH II Cable System
Chapter 6
6-9
Use Figure 6.6 for reference when connecting two trunkline segments to a tap.
Figure 6.6
Connect
two trunkline segments to a tap.
Dropline
Trunkline
Segment
Tap
12651
Trunkline
Segment
Secure each cable in place with some form of strain-relief device to help make
sure that:
you adhere to the bend-radius of the cable
the cable is not accidentally pulled out of its plug
When you connect a dropline to an interface module, make sure that the
bend-radius is not less than 3 inches (7.6 cm). If there is not enough room to
adhere to the bend-radius specification, you must remount the tap following the
instructions provided earlier in this chapter.
Install the Droplines