Instruction Manual
Planning a DH II Cable System
Chapter 5
5-7
You can order terminators from the following manufacturer:
Trompeter Electronics, Inc.
31186 Labaya Drive
Westlake, Village, CA 91311
The part numbers for the terminators are:
Component: Manufacturer Part Number:
Plug connector TNG11150
Jack connector TNGBJ11150
For information on installing terminators, refer to Chapter 6.
To install a DH II cable system you will need a stripping and a crimping tool for
RG-11 cable. You may use the following tools, or equivalents:
Table 5.B
Recommended
stripping and crimping tools.
Part Manufacturer Part Number
Crimping Tool AMP 2200151
Stripping Tool Ideal Industries 45164
These manufacturers can be contacted at the following addresses.
AMP Inc.
Harrisburg, PA 17105
Ideal Industries
4450 Becker Pl.
Sycamore, IL 60178
Necessary Tools