Owner manual

HART Command Data Table Layouts
Appendix A
A-9
Standard Outputs
Integer Word 30 STT Subroutine Status Wordg
Word 31 STT Subroutine Error Code
Word 32 Smart Transmitter Interface Status Word
Word 33 Smart Transmitter Interface Error Code
Word 34 HART ProtocolCommunication Error Code
Word 35 HART Command Response Summary Code
Word 36 HART Field Device Error Code
Commandspecific Outputs
Integer Word 40 Primary Variable Range Values Unit Code
Floatingpoint Word 10 Primary Variable Upper Range Valuegp
Word 11 Primary Variable Lower Range Value
Data Table Report PLC-5/25 Addr 31 Data Table File N10:0
Address 0 1 2 3 4 5 6 7 8 9
N10:0 4 6 3 0 16 35 9858 269 12807 0
N10:10 0 0 0 0 0 0 0 0 0 0
N10:20 0 0 0 0 0 0 0 0 0 0
N10:30 4 0 128 0 0 0 0 0 0 0
N10:40 32 0 0 0 0 0 0 0 0 0
N10:50 0 0 0 0 0 0 0 0 0 0
This integer word is a commandspecific output
that should contain the unit code that you
entered for the primary variable (see page B5).
These seven integer words are the standard outputs
that contain the status of the communications with
the HART field device. (see page 36).
Data Table Report PLC-5/25 Addr 31 Data Table File F11:0
Address 0 1 2 3 4
F11:0 100.0 0.0 0 0 0
F11:5 0 0 0 0 0
F11:10 100.0 0.0 0 0 0
F11:15 0 0 0 0 0
These two floatingpoint words are commandspecific
outputs that should contain the new upper and lower
range values that you entered for the primary variable.
HART Command 35
Write Primary V ariable Range
Values