User Manual

Chapter 3
Configuring the Module
Chapter 3 provides instructions and information for configuring the
1769-SM1 module.
For a list of parameters, refer to Appendix
B, Module Parameters. For
definitions of terms in this chapter, refer to the Glossary.
The 1769-SM1 module stores parameters and other information in its
own non-volatile memory. You must, therefore, access the module to
view and edit its parameters. The following tools can be used to access
the module parameters.
For DPI (PowerFlex)-Supported System:
For SCANport or DPI (PowerFlex)-Supported System:
Topic Page Topic Page
Configuration Tools
3-1 Setting the I/O Configuration 3-15
Configuration Methods 3-2 Setting an Idle Action 3-16
Controller Mode 3-2 Resetting the Module 3-17
Parameter Mode 3-13 Viewing the Module Configuration 3-18
Using the PowerFlex HIM 3-14
Configuration Tools
Tool Refer to…
DriveExplorer Software
(version 3.01 or higher)
http://www.ab.com/drives/driveexplorer, and
DriveExplorer online help (installed with the software
DriveExecutive Software
(version 1.01 or higher)
http://www.ab.com/drives/drivetools, and
DriveExecutive online help (installed with the software
PowerFlex HIM on PowerFlex drive Page 3-14
RSLogix 500 LG500-GR001…
RSLogix 5000 9399-RLD300GR
Tool Refer to…
RSLogix 500 LG500-GR001…
RSLogix 5000 9399-RLD300GR