User Manual

1-6 Getting Started
This section is provided to help experienced users quickly start using the
1769-SM1 Compact I/O to DPI/SCANport module. If you are unsure
how to complete a step, refer to the referenced chapter.
Quick Start
Step Action Refer to…
1 Review the safety precautions for the module. Throughout this manual
2 Verify that the drive is properly installed. Drive User Manual
3 Install the module.
Verify that the controller is not powered. Then, connect
the module to the controller backplane bus, and to the
drive using a Bulletin 1202-Cxx communications cable.
Chapter
2,
Installing the Module
4 Apply power to the module.
The module receives power from the controller. Apply
power to the controller. The MODULE indicator should
be green. If it flashes red, there is a problem. Refer to
Chapter
8, Troubleshooting.
5 Configure the module for your application.
Set the following parameters for the module as required
by your application:
• I/O configuration.
• Fault actions.
Chapter
3,
Configuring the Module
6 Apply power to the drive.
Verify that the drive is installed properly, and then apply
power to it.
Network Cable System
Planning and Installation
Manual
7 Configure the controller to communicate with the
module.
Depending on controller
type:
• Chapter
5,
MicroLogix 1500
Ladder Example
Program
• Chapter 6,
CompactLogix Ladder
Example Program
• Chapter 7,
ControlLogix w/
1769-ADN DeviceNet
Ladder Example
Program
8 Create a ladder logic program.
Use a programming tool such as RSLogix to create a
ladder logic program that enables you to do the
following:
• Control the module and connected drive.
• Monitor or configure the drive using Explicit
Messages.