User Manual

A-2 Specifications
NOTE: In order to remain CE and CTick compliant, the DPI/SCANport
cable length may not exceed 10 m (32.8 ft.).
NOTE: In a domestic environment this product may cause radio inter-
ference in which case supplementary mitigation measures may be required.
Maximum cable distance between the 1769-SM1 and connected device:
• The maximum cable length is the SUM of all connected cables
between the drive and peripheral(s). This includes all cables
connected via the DPI Screw Terminal cable, 1203-S03 splitter
cable, and 1203-SG2/1203-SG4 expander modules.
• Installer must follow common system wiring practices and route
cables away from sources of EMI.
• 1202-Hxx Extension cables are recommended for extending the
1202-Cxx cable length.
Environmental
Temperature
Operating
Storage
-10 to 50°C (14 to 122°F)
-40 to 85°C (-40 to 185°F)
Relative Humidity -5 to 95% non-condensing
Atmosphere Important: The 1769-SM1 must not be installed in an area where
the ambient atmosphere contains volatile or corrosive gas, vapors,
or dust. If the module is not going to be installed for a period of
time, it must be stored in an area where it will not be exposed to a
corrosive atmosphere.
Shock
Operational
Non-operational
30g, 11 ms
50g, 11 ms
Vibration
Operational
Non-operational
5g, 10 to 500 Hz.
5g, 5 to 2000 Hz.
Regulatory Compliance
UL UL508C
cUL CAN / CSA C22.2 No. 14-M91
CE EN50081-2 and EN61000-6-2
CTick AS/NZS 2064, 1997, Group 1, Class A
DPI/SCANport Cable Requirements/Recommendations
SCANport Host (1336, 1305, etc.) 10 m (32.8 ft.)
DPI Host (PowerFlex, etc.) 75 m (246 ft.) with 500 kbps DPI data rate
100 m (328 ft.) with 125 kbps DPI data rate