User Manual Manual

60 Publication 1769-UM009E-EN-P - August 2009
Chapter 4 Automatically Configure a DeviceNet Network
Put the Scanner in
Run Mode
Follow these steps to run the DeviceNet network.
1. Place the controller in Run/Remote Run mode.
2. Set the following bit of the output structure for the scanner.
3. Check to see if the scanner is in Run mode, by making sure an 80 status
code does not appear on the scanner’s display.
If you want to Set this bit To:
run the network …O.CommandRegister.Run 1
not run the network (idle mode) …O.CommandRegister.Run 0