User manual

20 Rockwell Automation Publication 1769-UM011I-EN-P - February 2013
Chapter 2 Install the 1769-L3x Controllers
Node address switches are set to the 99 position at shipment, as shown in the
figure.
Use these steps to set the node address.
1. Slide the side cover forward.
2. Use a small screwdriver to set the node address via the controller switches.
3. Write the node address on the front panel overlay after setting the node
address switches.
Connect the 1769-BA Battery
The controller is shipped with the 1769-BA battery that is packed separately. To
connect the battery, follow this procedure.
43868
43860
0
5
1
2
3
4
6
7
9
8
0
5
1
2
3
4
6
7
9
8
31504-M
ATTENTION: The 1769-BA battery is the only battery you can use with the
1769-L32E and 1769-L35E controllers. The 1747-BA battery is not compatible
with the 1769-L32E and 1769-L35E controllers and may cause problems.