Quick Start Owner manual

84 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 7 Configure the EtherNet/IP Network
5. Double-click a request
from one of the devices.
6. Enter the corresponding
IP address that you
selected from the
Network Worksheet
.
If you are not using an
isolated network,
obtain these numbers
from your network
administrator.
7. Repeat steps 5
and 6 for
all devices, except the
PanelView Plus terminal
(the IP address for the
PanelView Plus terminal
was set in Chapter 6
).
If a device is power
cycled, it will not retain its
IP address unless you
disable BOOTP/DHCP.
8. Select the first device in the Relation List and click Disable BOOTP/DHCP.
[Disable BOOTP/DHCP] Command successful appears in the Status bar.
9. Repeat step 8 for all devices, except the PanelView Plus.
10. Close the BOOTP/DHCP Server utility.
If you are prompted to save changes, click No.