Installation Instructions Instruction Manual

28 1769-L32C, 1769-L35CR CompactLogix Controller
Publication
1769-IN070C-EN-P - May 2008
Connect the Controller to the Network Via a ControlNet Tap
Typically, ControlNet taps are used to make permanent connections from the
CompactLogix controller to the network. Perform the following steps to
connect the module to the network by using a ControlNet tap.
1. Remove and save the dust caps from the ControlNet taps.
ATTENTION
Do not allow any metal portions of the tap to contact any conductive material.
If you disconnect the tap from the module, place the dust cap back on the
straight or right angle connector to prevent the connector from accidentally
contacting a metallic grounded surface.
Item Description
1 Segment 1
2 Segment 2
3 Dust caps
1
2
3