Installation Instructions Instruction Manual

1769-L31 CompactLogix Controller 17

Publication

1769-IN069C-EN-P - May 2008

Default Serial Configuration

Channel 0 and Channel 1 (both serial ports) have the following default

communication configuration.

Yes

The 1761-CBL-AP00 cable (right-angle connector to controller) or the

1761-CBL-PM02 cable (straight connector to the controller) attaches the

controller to port 2 on the 1761-NET-AIC isolator. The mini-DIN connector is

not commercially available, so you cannot make this cable.

Parameter Default

Protocol DF1 Full-duplex

Communication Rate 19.2 Kbps

Parity None

Station Address 0

Control Lines No Handshaking

Error Detection BCC

Embedded Responses Auto Detect

Isolator Use Cable

DB-9 Right-angle or Straight Cable End

8-pin, Mini-DIN Cable End

Pin DB-9 End Mini-DIN End

1 DCD DCD

2 RxD RxD

3TxD TxD

4DTR DTR

5 Ground Ground

6 DSR DSR

7 RTS RTS

8 CTS CTS

9N/A N/A

678