Quick Start Owner's manual
68 Rockwell Automation Publication IASIMP-QS025B-EN-P - December 2012
Chapter 5 Create a Logix Designer Project
Configure the Controller
1. Verify that your controller’s mode
switch is in the REM position.
2. Click the RSWho icon.
3. In the Who Active dialog box,
expand the path to the controller
and select it.
4. Click Set Project Path.
5. Click Download.
6. Click Download again when the
Download dialog box appears.
IMPORTANT
After the download is
complete, the controller goes
online.
You must be online to set the
controller’s IP address as
described in step 8…step 10.
RUN
REM
PROG