Quick Start Owner's manual

Rockwell Automation Publication IASIMP-QS025B-EN-P - December 2012 51
Configure the EtherNet/IP Network Chapter 3
5. Click the Port Configuration tab.
6. For Network Configuration Type, click
Static to permanently assign this
configuration to the port.
7. Enter the IP address and Network Mask for the controller.
8. Enter other network parameters, if desired.
9. Click OK.
For more information on setting the network IP address, see EtherNet/IP Network
Configuration User Manual, publication ENET-UM001
.
IMPORTANT
The controller’s default
configuration is Dynamic. When the
controller is configured for
Dynamic, on a power cycle, it clears
the current IP address and resumes
sending BOOTP requests.