Quick Start Owner's manual

44 Rockwell Automation Publication IASIMP-QS025B-EN-P - December 2012
Chapter 2 Prepare the Computer and Load Controller Firmware
6. Expand the USB driver, and
choose your controller.
7. Click OK.
8. Verify that your controller’s mode
switch is in the REM position.
9. Choose the desired firmware
revision and click Next.
TIP
Consider the following:
• If the Current Revision
matches the firmware
revision shown in the box
below it, click Cancel. You are
finished with this task.
• This example uses firmware
revision 21.001.23. Your
firmware revision may be a
different number.
You can access the latest
firmware revision at the
Rockwell Automation
Technical Support webpage.
RUN
REM
PROG