Quick Start Owner's manual

Rockwell Automation Publication IASIMP-QS025B-EN-P - December 2012 17

Chapter 1

Prepare the CompactLogix 5370 L2 Controller Hardware

This chapter describes the hardware required to install your CompactLogix 5370 L2 system.

Before You Begin

Determine which networks your control system uses. You can use CompactLogix 5370 L2

controllers on an EtherNet/IP network and on a DeviceNet network.

What You Need

Table 4 lists the hardware components used in this chapter. The parts listed in this table are done

so with the assumption that you will install an EtherNet/IP and DeviceNet network.

Table 4 - Parts Used with This Quick Start

Quantity Cat. No. Description

1 or more N/A DIN rail (steel, not aluminum)

1 1769-L27ERM-QBFC1B CompactLogix 5370 L2 controller

1 1606-XLDNET8 DeviceNet power supply

1 1769-ECR Compact I/O end cap/terminator

2 or more 1585J-M8PBJM-2 RJ45-to-RJ45 patchcord Ethernet cables

1 - USB cable with Type B receptacle

1 1783-EMS08T Stratix 6000 Ethernet managed switch

1 1606-XLDNET4 Standard switched-mode power supply

1 1769-OB16 Compact 16-point 24V DC sourcing output module

1769-SDN

Compact I/O DeviceNet scanner

1 1485C-P1E75 KwikLink flat cable, 75 m (246 ft)

2 1485A-T1E4 KwikLink terminator/resistor

2 or more 1485P-P1E4-R5 KwikLink sealed micro connector