Quick Start User guide

Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012 49
Configure the EtherNet/IP Network Chapter 3
5. Click the Port Configuration tab.
6. For Network Configuration Type,
click Static to permanently assign
this configuration to the port.
7. Enter the IP address and Network Mask for the controller.
8. Enter other network parameters, if necessary.
9. Click OK.
For more information on setting the network IP address, see EtherNet/IP Network
Configuration User Manual, publication ENET-UM001
.
IMPORTANT
The controller’s default
configuration is Dynamic.
When the controller is
configured for Dynamic, on a
power cycle, it clears the
current IP address and resumes
sending BOOTP requests.