Quick Start User guide

Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012 43
Prepare the Computer and Load Controller Firmware Chapter 2
6. Expand the USB driver, and select
your controller.
7. Click OK.
8. If it’s not in the position already,
move the mode switch on the
controller to the REM position.
9. Choose the desired firmware
revision and click Next.
TIP
Consider the following:
• If the Current Revision
matches the firmware
revision shown in the box
below it, click Cancel. You are
finished with this task.
• This example uses firmware
revision 21.001.23. Your
firmware revision may be a
different number.
You can access the
latest firmware revision
at the Rockwell
Automation Technical
Support webpage.
RUN
REM
PROG