Quick Start User guide

Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012 29
Prepare the CompactLogix 5370 L1 Controller Hardware Chapter 1
Make EtherNet/IP Network Connections
This section assumes you installed an EtherNet/IP network as described on page 19 and the
network includes a 1783-EMS08T Stratix 6000 Ethernet managed switch.
1. Plug a 1585J-M4TBJM-1,
Ethernet cable (straight-through)
into a port on the Stratix 6000
switch.
2. Plug the other end of the Ethernet
cable into one of the Ethernet
ports on the bottom of the
controller.
Set the Network IP Address
Once you connect the CompactLogix 5370 L1 controller to an EtherNet/IP network, you must
assign the controller a unique IP address. For information about how to set the network IP
address for your controller, see Chapter 3, Configure the EtherNet/IP Network
on page 45.
1
2
34
56
78
00:00:BC:2E:69:F6