Quick Start User guide

Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012 15
Preface
Parts List
Tabl e 3 lists the hardware used in this quick start. Specific hardware requirements are listed at the
beginning of each chapter.
Additional Resources
These documents contain additional information concerning related products from
Rockwell Automation.
Table 3 - Parts Used with This Quick Start
Quantity Cat. No. Description
1 or more N/A DIN rail (steel, not aluminum)
1 One of the following:
• 1769-L16ER-BB1B
• 1769-L18ER-BB1B
• 1769-L18ERM-BB1B
CompactLogix 5370 L1 controller
The tasks described in this publication use a 1769-L18ERM-BB1B controller.
1 1606-XLP50E Switched-mode power supply
1 1734-OB4E POINT I/O 8-point 24V DC electronically-fused output module
1 1783-EMS08T Stratix 6000 Ethernet managed switch
1 1585J-M8PBJM-2 RJ45-to-RJ45 patchcord Ethernet cables
Table 4 - Additional Resources
Resource Description
CompactLogix 5370 Controllers User Manual,
publication 1769-UM021
Describes how to design, install, operate, and troubleshoot a CompactLogix 5370
control system.
Logix5000 Control Systems: Connect POINT I/O
Modules over an EtherNet/IP Network Quick
Start, publication IASIMP-QS027
Describes basic steps required to include distributed POINT I/O modules over an
EtherNet/IP network in a Logix5000 control system, including hardware, firmware,
and software considerations.
Logix5000 Control Systems: Connect a
PowerFlex 40 Drive over a EtherNet/IP Network
Quick Start, publication IASIMP-QS029
Describes basic steps required to include PowerFlex 40 drives over an EtherNet/IP
network in a Logix5000 control system, including hardware, firmware, and software
considerations.
Logix5000 Control Systems: Connect a
PowerFlex 70 Drive over an EtherNet/IP
Network Quick Start, publication IASIMP-
QS031
Describes basic steps required to include PowerFlex 70 drives over an EtherNet/IP
network in a Logix5000 control system, including hardware, firmware, and software
considerations.