User Manual

Rockwell Automation Publication 1769-UM004B-EN-P - March 2010 41
Module Data, Status, and Channel Configuration Chapter 4
Configuration Data File
The default value of the configuration data is represented by zeros in the data
file. The structure of the channel configuration file is shown below.
The configuration file can also be modified through the control program, if
supported by the controller. For information on configuring the module in a:
• MicroLogix 1500 system by using RSLogix 500 software,
see Appendix
E.
• CompactLogix system by using RSLogix 5000 software,
see Appendix
F.
• 1769-ADN DeviceNet adapter by using RSNetWorx software,
see Appendix
G.
The structure and bit settings are shown in Channel Configuration
on page 42.
Word/
Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0
Enable
Channel
0
Data Format
Channel 0
Input Type
Channel 0
Temperature
Units Channel
0
Open-circuit
Condition
Channel 0
Not
Used
Not
Used
Filter Frequency Channel 0
1
Enable
Channel
1
Data Format
Channel 1
Input Type
Channel 1
Temperature
Units Channel
1
Open-circuit
Condition
Channel 1
Not
Used
Not
Used
Filter Frequency Channel 1
2
Enable
Channel
2
Data Format
Channel 2
Input Type
Channel 2
Temperature
Units Channel
2
Open-circuit
Condition
Channel 2
Not
Used
Not
Used
Filter Frequency Channel 2
3
Enable
Channel
3
Data Format
Channel 3
Input Type
Channel 3
Temperature
Units Channel
3
Open-circuit
Condition
Channel 3
Not
Used
Not
Used
Filter Frequency Channel 3
4
Enable
Channel
4
Data Format
Channel 4
Input Type
Channel 4
Temperature
Units Channel
4
Open-circuit
Condition
Channel 4
Not
Used
Not
Used
Filter Frequency Channel 4
5
Enable
Channel
5
Data Format
Channel 5
Input Type
Channel 5
Temperature
Units Channel
5
Open-circuit
Condition
Channel 5
Not
Used
Not
Used
Filter Frequency Channel 5
6Reserved
Enable/Disable
Cyclic
Calibration