User Manual Manual

76 Rockwell Automation Publication 1766-UM001H-EN-P - May 2014
Chapter 5 Using the LCD
• The TUF element of the LCD Function File is set to 7 to specify the
integer file N7 as the target integer file to monitor on the LCD, as shown
in the screen capture below.
• The controller mode is set to REMOTE RUN.
Follow these steps to view and change the data values of the integer file N7.
1. On the Main Menu screen, select Monitoring by using the Up and Down
keys on the LCD keypad.
2. Press the OK key on the LCD keypad. The File Number prompt is
displayed.
3. If Integer is selected, as shown in step 2, press the OK key.
If not selected, press the Down key to select it and then press the OK key.