Quick Start

30 Publication IASIMP-QS037A-EN-P - May 2013
Chapter 1
appear at the top of the list. Alarms remain in the list until the Clear All
Alarms button is pushed on the maintenance screen.
Because this list contains past alarms (history), use the UP/DOWN and
PAGE UP/PAGE DOWN buttons to scroll through the list.
From this screen you can also:
– Press View Warnings to go to the Warning screen. Refer to Warning
Screen on page 27.
– Press Alarm Output Config to go to the Alarm Output
Configuration screen. Refer to Alarm Output Configuration on
page 32.
– Press View VFD Alarms to view PowerFlex 4 alarms, if a PowerFlex
4 VFD is being used. Refer to VFD Faults (PowerFlex 4 VFDs only)
on page 31.
List of available alarms:
System Interlock I:0/19 Not Energized Pump #2 Failed To Run
High Level PowerFlex VFD #2 Comm Loss
Low Level Pump #2 OL Tripped/VFD Fault
High Pressure Pump #2 Over Temp
Low Pressure Pump #2 Seal Fail
Analog Input I:1.0 Out Of Range Pump #3 Failed To Run
Analog Input I:1.1 Out Of Range PowerFlex VFD #3 Comm Loss
Power Failure Pump #3 OL Tripped/VFD Fault
Generator Running Pump #3 Over Temp
Generator Fault Pump #3 Seal Fail
General Fault Pump #4 Failed To Run
Pump #1 Failed To Run PowerFlex VFD #4 Comm Loss
PowerFlex VFD #1 Comm Loss Pump #4 OL Tripped/VFD Fault
Pump #1 OL Tripped/VFD Fault Pump #4 Over Temp
Pump #1 Over Temp Pump #4 Seal Fail
Pump #1 Seal Fail