Manualshelf

Installation Instructions Owner's manual

ManualsBrandsRockwell Automation ManualsEquipment1763-L16xxx MicroLogix 1100 Programmable Controllers
11121314151617181920
15
Publication 1763-IN001B-EN-P - September 2007
Connec
ting 1762 I/O Expansion Module
s
Connect 1762 I/O after mounting the controller.
1. Remove the expansion port cover to install expansion I/O modules.
2. Plug the ribbon cable connector into the bus connector.
3. Replace the cover as shown below.
The MicroLogix 1100 controller is designed to support up to any four 1762
expansion I/O modules.
For detailed information on using expansion I/O, refer to the installation
instructions for your expansion module.
ATTENTION
Remove power to the system before installing or removing expansion I/O or damage to the
controller may result.