Installation Instructions Manual

8 MicroLogix 1200 Programmable Controllers
Publication 1762-IN006C-EN-P - September 2009
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or non-hazardous
locations only. The following WARNING statement applies to use in hazardous locations.
Use only the following communication cables in Class I, Division 2 hazardous locations.
Catalog Number Description
Input Power Inputs Outputs
1762-L24AWA, -L24AWAR 120/240V ac (14) 120V ac (10) relay
1762-L24BWA, -L24BWAR 120/240V ac (10) 24V dc
(4) fast 24V dc
(10) relay
1762-L24BXB, -L24BXBR 24V dc (10) 24V dc
(4) fast 24V dc
(5) relay, (4) 24V dc FET
(1) high-speed 24V dc FET
1762-L40AWA, -L40AWAR 120/240V ac (24) 120V ac (16) relay
1762-L40BWA, -L40BWAR 120/240V ac (20) 24V dc
(4) fast 24V dc
(16) relay
1762-L40BXB, -L40BXBR 24V dc (20) 24V dc
(4) fast 24V dc
(8) relay, (7) 24V dc FET
(1) high-speed 24V dc FET
WARNING
EXPLOSION HAZARD
Substitution of components may impair suitability for Class
I, Division 2.
Do not replace components or disconnect equipment
unless power has been switched off.
Do not connect or disconnect components unless power
has been switched off.
This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or
be protected by conduit or other means.
All wiring must comply with N.E.C. article 501-4(b).