Owner manual

18 MicroLogix 1200 RTD/Resistance Input Module
Publication 1762-IN014B-EN-P - July 2013
Module Configuration Word
Word 4 of the configuration data file contains the Enable/Disable Cyclic Calibration bit, as
shown in the table below.
Data Format
Raw/Proportional 0 0 0
Engineering Units 0 0 1
Engr. Units X 10 1 0 0
Scaled-for-PID 0 1 0
Percent Range 0 1 1
Enable
Channel
Enable 1
Disable 0
To Select Make these bit settings
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Cyclic
Calibration
Enabled
(1)
(1) When enabled, an autocalibration cycle is performed on all enabled channels every 5 minutes.
0
Disabled 1
To Select
Make these bit settings
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0