Programmer (HHP) User guide

5
Chapter
5–1
Quick Start for New Users
This chapter can help you get started using the MicroLogix 1000 HHP with
your micro controller. It provides task-oriented procedures to guide you
through a hands-on practice exercise.
Before you begin you should have completed the following tasks:

✔
Your
controller should be installed and wired. (See chapters 1 and 2.)

✔
Your HHP should be connected and powered-up. (See chapters 3 and 5.)
Here’s what you’ll be doing to get started with the MicroLogix 1000 HHP:
 Preparing to enter a new program
 Placing the controller in program mode
 Clearing the current program
 Entering and running the program
 Entering the new program
 Changing to run mode
 Monitoring operation
 Monitoring the program

Monitoring the data
Once you’ve finished these steps you will have a good idea of what it takes
to program your micro controller with a MicroLogix 1000 HHP. You will
also know how to execute and monitor program activity.
If Y ou’d Like More Examples
Be sure you read the last section in this chapter. It directs you to more
examples throughout the manual.
What to Do First