Programmer (HHP) User guide
(HHP) User Manual
Index
MicroLogix
1000 with Hand-Held Programmer
I–10
using the MSG instruction, 15–12
application specific instructions
about, 13–1
bit shift instructions, overview
, 13–2
Bit Shift Left (BSL), 13–3
Bit Shift Right (BSR), 13–4
in the paper drilling machine application
example, 13–20
Selectable T
imed Interrupt (STI) function,
overview
, 13–15
sequencer instructions, overview
, 13–6
applying logic to your schematics, 6–1
1
B
basic instructions
about, 8–2
bit instructions, overview
, 8–3
branch instructions, overview
, 8–9
counter instructions, overview
, 8–21
in the paper drilling machine application
example, 8–28
timer instructions, overview
, 8–14
baud rate
changing, 19–6, 19–7
limitations for autoswitching, 3–13
bidirectional counter
operation, 14–9
overview
, 14–5
bidirectional counter with quadrature encoder
operation, 14–13
overview
, 14–5
bidirectional counter with reset and hold
operation, 14–9
overview
, 14–5
bidirectional counter with reset and hold with
quadrature encoder
operation, 14–13
overview
, 14–5
bit file (B), 6–4
bit instructions
And (AND), 8–3
And Block (ANB), 8–12
And Inverted (ANI), 8–4
Load (LD), 8–3
Load Inverted (LDI), 8–4
Load T
rue (LDT), 8–6
Memory Pop (MPP), 8–10
Memory Push (MPS), 8–10
Memory Read (MRD), 8–10
One-Shot Rising (OSR), 8–7
Or (OR), 8–3
Or Block (ORB), 8–12
Or Inverted (ORI), 8–4
Or T
rue (OR
T), 8–6
Output (OUT), 8–8
overview
, 8–3
Reset (RST), 8–8
Set (SET), 8–8
bit shift instructions, overview
, 13–2
ef
fects on index register S24, 13–3
entering parameters, 13–2
entering the instructions, 13–2
Bit Shift Left (BSL), 13–3
ef
fects on index register
, 13–3
entering parameters, 13–2
entering the instruction, 13–3
execution times, 13–3
function code, 13–3
instruction parameters, C–3
ladder representation, 13–3
operation, 13–4
valid file types, C–3
Bit Shift Right (BSR), 13–4
ef
fects on index register
, 13–3
entering parameters, 13–2
entering the instruction, 13–4
execution times, 13–4
function code, 13–5
instruction parameters, C–3
ladder representation, 13–4
operation, 13–5
valid addressing modes, C–3
valid file types, C–3
branch instructions, overview
, 8–9
branching
input, 6–13
nested, 6–14
output, 6–13
BSL, Bit Shift Left, 13–3
BSR, Bit Shift Right, 13–4
C
cables
planning routes for DH-485 connections,
D–13
selection guide for the AIC+, 3–8
selection guide for the DeviceNet network,
3–14
Calculating the Software Calibration, F–2
calibrating an analog input channel, F–1
CE mark, 1–1