Programmer (HHP) User guide

Chapter 19
Common Procedures
19–9
6. The DH-485 node address sub-menu appears next.
D H 4 8 5 N O D E 1 3 1
A D D R : 1
To accept the default setting (1), press ENT.
To change the default setting, delete the 1 by pressing DEL, type in the
new number, and then press
ENT.
A P P L Y C O M M S
Y E S [ E N T ] N O
E S C ]
7. Accept the communication settings.
ENT
A P P L Y I N G C O M M S
R E S E T
I N G U N I T
The MicroLogix 1000 HHP resets itself to the new communication settings
and runs through the power-up sequence.
Note: You cannot use the MicroLogix 1000 HHP to select or configure the
DF1 half-duplex slave protocol for Series D discrete or Series A
analog MicroLogix 1000 controllers.