Programmer (HHP) User guide

Chapter 19
Common Procedures
19–8
2. The default setting for the main protocol is DF1.
– To accept the default setting (DF1) , press ENT.
– To change the default setting, arrow right to select DH-485 and then
press
ENT.
The arrow points to the controller’s current DF1 baud rate.
9 6 0 0 D F 1
2 4 0 0 D F 1
3. Arrow down to the desired DF1 baud rate and select it.
n times
ENT
4. The DF1 node address sub-menu appears next.
D F 1 N O D E 0 – 2 5 4
A D D R : 1
– To accept the default setting (1), press ENT.
– To change the default setting, delete the 1 by pressing DEL, type in the
new number, and then press
ENT.
The arrow points to the controller’s current DH-485 baud rate.
1 9 2 0 0 D H 4 8 5
9 6 0 0 D H 4 8 5
5. Arrow down to the desired DH-485 baud rate and select it.
n times
ENT