Programmer (HHP) User guide

After Y ou’ve Entered Y our Program
Chapter 18
18–32
Changing Multi-Point Addresses
You can change an entry in the multi-point list by writing over the current
address. Follow the steps below.
1. Access the multi-point functional area.
+
MT PT
-
B
I
/ 3 I 0 M P
– – – – – – – 0 0 1 0 0 0 1 0
0
2. Arrow to the address you want to write over.
3. Bring up a prompt to enter the address.
+
MT PT
-
B
FUN
I
/ 3 I 0 M P
A D D R :
4. Enter the address of the new bit you want to monitor. B/0 is shown here
as an example:
ANB
0
ORB
+
-
/
+
MT PT
-
B
ENT
B / 0 B 0 M P
– – – – – – – 0 0
1
0 0 0 1 0
0
The new address is added to the multi-point list at the location you
selected in step 2.