Programmer (HHP) User guide

After Y ou’ve Entered Y our Program
Chapter 18
18–23
Tasks You Can Perform
This table shows you what tasks you are allowed to perform in each of the
possible modes.
cti it
Remote Controller Mode
A
cti
v
it
y
Program
Test Run Fault Suspend
Change the language. X X X X X
Accept program edits. X
Change the following program
configuration settings:
• Program Name
• Run Always
• Start-Up Protection
• Fault Override
• Extend I/O Configuration
• STI Enabled
• Input Filters
• Lock Program
X
Change the following program
configuration settings:
• User Password
• Master Password
• STI Setpoint
• Watchdog Scan
X X X X X
Load and store programs using the
memory module.
X
Clear programs in the memory module. X X X X X
Clear all forces. X X X X X
Clear a program in the controller. X X X
Change the baud rate and contrast. X X X X X
Change to a different mode. X X X X
Run your program with output points
disabled.
X
View faults manually. X X X X X
Force inputs and outputs. X X X X X
Monitor and edit the program in the
controller (without rung state indication).
X
Monitor the program, rung state, and
data as it is being executed.
X X
Monitor and edit data files. X X X X X
Change the radix. X X X X X
Use the search, trace, and multi-point
functions.
X X X X X
Access the function code table. X X X X X