Programmer (HHP) User guide

After
Y
ou’ve Entered
Y
our Program
Chapter 18
18–16
Configuring the Analog Output
The analog controllers output channel can be configured to support either
current or voltage operation.
To configure the analog output:
1. Put the controller in RPRG mode (if it is not already in that mode).
2. Access the program configuration menu.
6
times
ENT
3. Arrow up to the option ANALOG CONFIG and select it.
2
times
ENT
Note: The function is only available when the Micro Term is attached to an
analog controller.
F I L T E R S E T T I N G
O U T P U T C O N F I G
4. Arrow up to the option OUTPUT CONFIG and select it.
1
time
ENT
5. Arrow up/down to move between the two settings (0 – 10V or 4 – 20 mA).
6. Enter to store the selected setting and return to the ANALOG CONFIG
submenu.
ENT
7. Escape to return to the to ANALOG CONFIG submenu without storing the
current setting.
ESC