Programmer (HHP) User guide

18
Chapter
18–1
After You’ve Entered Your Program
This chapter shows you the procedures for:
• changing the program configuration defaults
• accepting your program edits
• changing processor modes
• monitoring your controller
• viewing data table files
• using the multi-point function
• forcing inputs and outputs
Every default
MICRO program is configured with the settings shown in the
table below. The table shows the default program configuration settings and
indicates whether you need to save your program for the configuration
changes to take affect.
Program Configuration Default Setting
Must Save Program
for Change to Take
Affect
See Page
Program Name MICRO Yes 18–2
User Password No password No 18–2
Master Password No password No 18–2
Run Always No Yes 18–5
Start-Up Protection No Yes 18–6
Fault Override No Yes 18–7
Extended I/O Configuration➀ No Yes 18–8
STI Setpoint 0 (x 10 ms) No 18–9
STI Enabled Yes Yes 18–10
Watchdog Scan 10 (x 10 ms) No 18–11
Input Filters 8.00 msec for all groups Yes 18–12
Analog Config
Channel Enable
Filter Setting
Output Config
All Channels Enabled
60 Hz
Voltage Output
Yes 18–14
Lock Program No Yes 18–17
Controller Version
Series A and B discrete
controllers
Yes 18–18
➀
Valid for Series A – C discrete only.
Changing the Program
Configuration Defaults