Programmer (HHP) User guide

Chapter 14
Using High-Speed Counter Instructions
14–20
This instruction allows you to write a specific value to the hardware
accumulator and image accumulator.
The Counter referenced by this instruction has the same address as the HSC
instruction counter and is fixed at C0.
Entering Parameters
Enter the following parameter when programming this instruction:
• Source represents the value that is loaded to the accumulator. The source
can be a constant or an address.
Entering the Instruction
You enter the instruction from within the program monitor functional area.
The following items apply when entering the instruction:
• Whenever you see asterisks on the display, the HHP is waiting for data
entry (i.e., a number).
• You can return to previously entered operands by pressing this key:
Then if you want to edit that operand, press DEL or FUN-DEL and enter
new parameters. Press
ENT to accept the operand and move on to the next
one. Once the entire instruction is entered, if you want to edit the
instruction’s parameters, you must go into the overwrite mode. (See page
17–4.)
P
0 0 8 R A C C N T R
C 0 0
P
0 0 8 R A C S R C
* * * * * 1
Once instruction entry is complete, the parameters appear as shown here:
P
0 0 8 R A C C 0 0
P 1 A – 1
P
0 0 8 R A C S R C
1
RAC
RESET TO ACCUM VALUE
Counter C5:0
Source 1
Execution Times (µsec) when:
True False
56.00 6.00
Ladder representation:
High-Sp
ee
d
Count
e
r
Rese
t
Accumulator (RAC)
2
L
ENT
To enter the function code, press:
7
1
FUN