Software User Manual FRN 1.2 Owner manual

Publication 1758-UM002D-EN-P - October 2010
298 Extension Modbus Protocol for DataSite Controllers (1758-FLO)
There is no event code for command number 16.
Command Number 17: Set Up the Calculation Input Parameters
Use command number 17 to set up the corresponding parameters, excluding
the gas component parameters, for one meter run.
Return codes for command number 16
Return Code Description
00 OK
01 Meter run is invalid
100 Pass code is incorrect
Other Invalid
Parameters for command number 17
Address Data Type Attribute Description
49025 u_short RW 17
49026 u_short R Return code
49027 u_short W Meter run (0…7)
49028 u_int W Pass code for user
49030…49034 — — Reserved
49035 u_short W Whether the meter run is enabled
0: Disable
1: Enable
49036 u_short W Type of measurement units
0: U.S.
1: Metric
49037 u_short W Accumulate
0: Do not accumulate
1: Accumulate
49038 u_short W Use automatic components
analysis instrument
0: Disable
1: Enable
49039 u_short W Calculation type
0: AGA3
1: AGA7
49040 u_short W Algorithm for the calculation of
the compressibility factor
0: Gas Analysis
1: HV-GR-CO2
2: GR-CO2-N2
49041 u_short W Run interval