Software User Manual FRN 1.2 Owner manual

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 189
7. To exit the Test Communication state, power the DataSite controller off
and on again.
Normal communication with the controller is resumed.
Reset the Communication Parameters
The following tables show the default values of the COM1, COM2 and
Ethernet communication parameters:
Default values of COM1, COM2 communication parameters
Parameter Name Default Value
Station 1
Protocol Modbus RTU
Master/Slave State Slave
Duplex Full
Baud rate (bps) 9600
Parity None
Data bits 8 bits
Stop bits 1 bit
Port type RS232
Timeout (10 ms) 100
Delay time (10 ms) 0
Default values of Ethernet communication parameters
Parameter Name Default Value
IP 192.168.100.75
Mask 255.255.255.0
Gateway 192.168.100.1
Port 502