Installation Instructions Owner's manual

DataSite Natural Gas Flow Meter and Remote Terminal Unit 7
Publication 1758-IN001C-EN-P - June 2011
Controller Spacing
When mounting the controller, allow 25 mm (1 in.) of space on all sides for adequate
ventilation, as shown below.
DIN Rail Mounting
A small Phillips screwdriver is required for the installation or removal of the controller. The
controller can be mounted to EN50022-35 x 7.5 DIN rails.
Follow these steps to install your controller on the DIN rail.
1. Mount your DIN rail.
Make sure that the placement of the controller on the DIN rail meets the
recommended spacing requirements.
2. Loosen the two clamp screws until the clamp can slide out.
3. Place the controller onto the DIN rail, using the rail hooks on the back of the
controller.
IMPORTANT
D
Do not remove the screws from the clamp, otherwise they will fall into the
chassis.
Top
Bottom
Side
Side
44375