Installation Instructions Owner's manual

6 DataSite Natural Gas Flow Meter and Remote Terminal Unit
Publication 1758-IN001C-EN-P - June 2011
Mounting the Controller
Most applications require installation in an industrial enclosure to reduce the effects of
electrical interference and environmental exposure. Locate your controller as far as possible
from power lines, load lines, and other sources of electrical noise such as hard-contact
switches, relays, and AC motor drives. For more information on proper grounding guidelines,
see the Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1
.
You can mount the controller either horizontally or vertically on DIN rails, but horizontal
mounting is recommended for thermal considerations.
Dimensions
ATTENTION
Be careful of metal chips when drilling mounting holes for your controller or other
equipment within the enclosure or panel. Drilled fragments that fall into the controller
could cause damage.
1758-FLO301, 1758-FLO302, 1758-RTU201, 1758-RTU202
13.0 cm
(5.12 in.)
5.6 cm
(2.20 in.)
21.3 cm
(8.395 in.)
44374